history of 'FreiFunkHowTo'
- Hint: If you want to remove the beer drinking guy from the front page, grab [this | http://www.jawug.za.net/out-en.tar] file. Use the Publish page of the Web interface to upload it. Ignore the errors.
|
+ !! FreiFunk Howto
- Other interesting bits:
+ !! Other interesting bits:
|
+ Other interesting bits:
+ If you want to use PPPoE over your wireless interface, you will have to SSH into your device, and run these commands:
+ <code>
+ nvram set pppoe_ifname=eth1
+ nvram commit
+ </code>
|
+ Set up all your Wireless stuff in the Wireless menu. %%%
+ Remember, that if you set it up as a client, it is NOT a bridge. You will have to do routing.
+ Set up all the LAN stuff in the LAN menu.
+ Set up all the WAN stuff in the WAN menu. WAN refers to the Internet Ethernet port on the back of your device. If you want to use it with ADSL/Sentech/iBurst, you will have to install the pppoecd package too!
|
+ Hint: If you want to remove the beer drinking guy from the front page, grab [this | http://www.jawug.za.net/out-en.tar] file. Use the Publish page of the Web interface to upload it. Ignore the errors.
|
(previous content completely removed)
+ Start by downloading the [FreiFunk Firmware| FreiFunk]. %%%
+ Upload the Firmware to your device, using either tftp or the web interface.%%%
+ The default username is "root" and the password is "admin"
|
(previous content completely removed)
+ Start by downloading the [FreiFunk Firmware| FreiFunk].
|
JAWUG