JAWUG

Still incomplete...feel free to fill in guys

Setting up your WRT54G (With Freifunk firmware) to connect to wild_west_mesh

Firstly, make sure that you've upgraded to the latest Freifunk firmware! Read FreiFunkHowTo for more information. Then compare your settings to:

Contact

(The contact details are helpfull in identifying whose AP it is and how to contact them when there is a problem or updates)

Wireless Settings

WLAN Protocol: STATIC

WLAN-IP Address: 172.16.255.___ This is 172.16.255.64/26 = .65-.127

WLAN Netmask: 255.255.255.192

WLAN default route:

WLAN Mode: Adhoc

ESSID: **www.jawug.za.net/wildwest1,2,3,4 or 5+

Channel: 4 or 13

Card Type: 802.11a 802.11b/g Depends on ur WRT, b/g for Ver.2.2

RX Antenna: Auto Antenna A Antenna B Depends on your setup

TX Antenna: Auto Antenna A Antenna B Depends on your setup, usually same as above

TX Power: 84 is safe

Radio Mode: mixed b/g

Broadcast (E)SSID: Enable Disable Enable

Basic Rate: Default

Transmission Rate: Auto

CTS Protection Mode: Auto

Frame Burst: Enable

Beacon Interval: 100

DTIM Interval: 1

Fragmentation Threshold: 2346

RTS Threshold: 2347

MTU Value:

LAN Settings

LAN Protocol:

LAN IP:

LAN Netmask:

LAN default route:

Static Routes:

Disable NAT:

Disable Firewall:

DHCP Start IP: NETWORK.

DHCP Number of Users: (DHCP off with "0")

DHCP Lease Time: seconds

WAN Settings

WAN Protocol:

WAN IP:

WAN Netmask:

WAN default route:

DNS Server:

Host Name:

Domain:

RJ45 Connectors:

Permit SSH:

Permit HTTP:

Permit Ping:

OLSR Settings

OLSR Filter:

DMZ Redirect:

OLSR DHCP:

HNA4:

IP4 Broadcast:

Willingness:

QOS Protocol (ETX): Enable Disable

OLSR LQ-Multiplier:

Hysteresis: Enable Disable

Hysteresis Scaling:

High Threshold:

Low Threshold: DynGW: Enable Disable Nameservice: Enable Disable Httpinfo: Enable Disable

Linking your LAN interface to OLSR so that your LAN subnet is advertised...

SSH into your AP ssh 0dHdlB%2BLztdfic%3D">root»172.5.__

go to /etc/ cd /etc

Make local.olsrd.conf writable cp local.olsrd.conf local.olsrd.conf.bak

edit local.olsrd.conf vi local.olsrd.conf

Reboot reboot